Q1.09. Can the user calibrate the load cells and displacement before inserting a sample?

Yes, the user needs to calibrate the load cell before inserting the sample.

Calibration of the load cell must be done before each test. In particular the load cell should be zeroed after the tensile sample has been clamped in the stationary jaw, and before it is clamped in the movable jaw.

01/15 - Technical data subject to change without further notice

MicroMecha - 4, rue Augustin Fresnel - 57070 Metz, France - T: +33 (0)3 87 37 54 30